Owner's manual

Section 9 - Appendix Vlinx VESP211 Serial Server
Page 61 of 66 Manual Documentation Number: VESP211-5011m
www.bb-elec.com/
www.bb-europe.com/
Controls, Indicators and Connector Specifications
Switches
Reset button
Hold in for 0 to 2 seconds for hardware reset
Hold in for 2 to 10 seconds for Console Mode (Do a hardware reset
or recycle power to exit Console Mode)
Hold in for more than 10 seconds to reset to factory defaults
Indicators
Serial LED
Color = Green
On = Port open
Blink = Data traffic
Ethernet LED
Color = Yellow or Green
On = 100BaseTX
Off = 10BaseT
Blink = Data traffic
Ready LED
Color = Green
Blink (once per second) = System OK
Off = System NOT OK
Connectors
10BaseT/100BaseTX Ethernet
Single RJ-45F (8 pin)
Serial
VESP211: DB9 connector
VESP211-232: DB9 connector
VESP211-485: terminal block connector
DC Power
barrel connector
Serial Interface Specifications
Serial Interfaces
Mode Selection
RS-232/422/485 software selectable
RS-232 lines
TXD, RXD, RTS, CTS, DTR, DSR, DCD, GND
RS-422 lines
TXDA(-), TXDB(+), RXDA(-), RXDB(+), GND
RS-485 lines (2 wire)
Data(-), Data(+), GND
RS-485 lines (4 wire)
TXDA(-), TXDB(+), RXDA(-), RXDB(+), GND
Baud Rates
75, 150, 300, 600, 1200, 2400, 4800, 7200, 9600, 14400, 19200,
28800, 38400, 57600, 115200, 230400
Data Bits
5, 6, 7, 8
Parity
None, even, odd, mark, space
Stop bits
1, 1.5, 2
Flow control
None, RTS/CTS, XON/XOFF
RS-422/485 biasing
Auto 1K ohm pullups and pulldowns
RS-422/485 termination
120 ohm with user-installed jumpers
RS-485 data control
Auto control via MCU