Installation manual

6
7
inserting a 9-volt battery in and out of it to learn how it works.
Once this is checked, find a convenient place inside the guitar
where the battery holder can be reached and that there is good
access to the snap. Also check that it is in a place that the battery
can be put in and out easily.
Recommended places are at the neck block or at the back of
the guitar.
Be sure that the entire adhesive surface will make full contact
with surface you are attaching it to. Clean the surface with a
moist cloth and let the moist dry completely. Remove the protec-
tive liners of the adhesive and install it. Press firmly for about 30
seconds to make it secure. It takes 72 hours for the adhesive to
achieve its final holding ability.
7. CONNECTING THE TRANSDUCERS AND WIRES TO THE
PREAMP.
Check the circuit board of the preamp and see the picture
at these instructions for connections. Connect the transducer,
battery cable harness and the output cable. Notice that the
AST
UST
Battery wire
Output wire
small holes on each connector of the transducer and battery
cable harness should point upwards. If UST or AST is connected
improperly a loud audible hum will occur. Make sure that they
are connected correctly.
7.1 Installing the remote control board ribbon wire
At the circuit board of the preamp and the remote control there
is a locking connector for the ribbon wire that connects to both.
With two fingers, pull the lock to open. One end at a time, insert
the ribbon with the writing on the ribbon facing up facing to the
slot in the locks at the circuit and then the remote control. Do not
force! Push the lock closed while holding the ribbon in place.
When transducer, battery wire and output cable are connected
to preamp, close the cover and insert and tighten the four
screws.
Turn the input gain controls fully clockwise- all the way up.
It is recommended to test the systems operation at this point.
Before you do this, make sure that the input gains are turned
fully clockwise- all the way up. Insert a battery and connect the
output cable to amplifier. You should hear it from the amplifier
when you tap on the transducer.
Ribbon wire
UST gainAST gain