User Manual

INSTALLATION PROCEDURES
3-1
SECTION 3
INSTALLATION PROCEDURES
When installing the washer – extractor, it is important to allow adequate clearance on all
sides of the machine. When multiple machines are installed, it is important to allow for the specified
minimum clearances between machines. The following table shows recommended minimum
clearances for the various freestanding models.
NOTE: The dimensions are approximate and subject to normal manufacturing tolerances. If
exact dimensions are required for construction purposes, request certified drawings
from the factory. We reserve the right to make changes at any time without notice.
Table.3-1 Dimension Clearances
Figure.3-1 Dimensions for construction
UNTIS
Detail
Metric US
SA Series Tilt
(A) Minimum rear clearance mm in 850 33.46
(B) Minimum clearance between machine and wall mm in 455 18
(C) Minimum clearance between machines mm in 850 33.46
(D) Minimum font clearance mm in 1200 47.24
A. DIMENSION CLEARANCES