User Manual

OPERATING INSTRUCTIONS
4-22
205 16 or 24 relay output.
207 Maximum RPM.
209 Temperature hysterisis (1 – 10 degrees C). 3 degrees C is default.
210 Temperature displayed in degrees C.
211 Temperature displayed in degrees F.
212 Maximum water level (10 -100cm).
213 Minimum water level for heating (230cm).
214 Display number of hours in operation.
215 Display total number of programs run.
216 Display number of wash programs run since last maintenance request.
217 Reset maintenance request.
218 Display and set the number of washes between maintenance requests.
219 Coast down safety timer. DO NOT MODIFY!
220 Deletes all programs and cycles from memory.
221 Copy from control to the memory card.
222 Copy from memory card to the control (programs and cycles only).
223 Copy from memory card to the control (programs, cycles and parameters).
225 Disables the ADVANCE key.
230 Maximum water level allowed during spin DO NOT MODIFY!
Maintenance Request
It is possible to set a number of wash programs to execute, following which the machine will call
for maintenance:
The message appears at the start of a program, and is repeated at the beginning of each wash
program until reset by a qualified service technician.
Disable the Machine
Function 118
Upon entering this function, the machine will not operate. The power must be cycled
(turned off, then back on) for the function to activate. Upon power up, the display will show:
To re – enable the machine, type 118 at prompt. START + RESET are not needed.
MAINT. REQ.
!