Installation manual

Sailmon Installation Manual V1.4 Page 70
CHECK THE SENSOR INSTALLATION
Sailmon has a very powerful diagnostic system where all sensors can be checked for proper operation.
Click the “Diagnostis” button.
You see a list of currently connected sensors. Click on the sensor to see which values it delivers. Click on the
value to get a preview of the raw sensor value.
You can change the Sensors name in the “NAME” field. This will allow an alternative name for this sensor. The
name will be visible within the calibration.
THE DIAGNOSIS WINDOW SHOWS EVERY VALUE THE RESPECTIVE SENSOR DELIVERES AT THE
MOMENT. VALUES WHICH HAVE BEEN DELIVERED BY THIS SENSOR BUT WHICH ARE NOT DELIVERED AT
THE MOMENT ARE SHADED TO GRAY.