Instruction Manual

| 17

Installation | NAIS-400 User Manual

• Fit the pole adapter plate to the GPS antenna using the 4 small

screws.

• Feed the cable attached to the GPS antenna through the pole.

• Mount the pole into position as shown in Figure 7.

Fig. 7 GPS Mounting

Figure 7 GPS antenna mounting

To surface mount the external GPS antenna, select a ﬂat clean sur-

face area that has a clear view of the sky. Mount the antenna using

the supplied gasket and the 4 threaded brass rods.

• Mark and drill the 4 mounting holes and a further hole in the center

if necessary for the GPS cable - use the supplied gasket as a tem-

plate.

• Install the 4 threaded rods into the 4 mounting holes on the under-

side of the GPS antenna.

• Install the gasket by ﬁrstly threading the attached cable through the

centre of the gasket.

¼ Note: the gasket has adhesive on both sides - remove the protec-

tive ﬁlm from one side and apply the gasket to the under-side of the

GPS antenna while lining up with the 4 mounting holes. Ensure the

surface mounting area is clean with no dirt, old paint or debris.

Thread the attached cable through the drilled cable hole.

• Remove the remaining protective ﬁlm and apply the GPS antenna to

the prepared mounting area with the threaded rods engaging the 4

drilled mounting holes.

• Use the 4 brass washers and nuts to secure the GPS antenna.