User guide

RemoteVision User Manual

Operation

HB-0913-02

Installing the Batteries

RemoteVision uses two “AA” Alkaline batteries located in the rear of the unit.

Most alternative batteries are also suitable though some types may have

magnetic properties that adversely affect compass accuracy. During battery

replacement, individual user settings are stored in non-volatile memory to prevent

loss of data.

It is recommended that the internal fluxgate compass is always re-swung after

battery replacement, to correct for possible magnetic differences between types

of battery. Refer to the Setup section of this user manual for further details.

Battery Replacement:

1. Using a coin, rotate the battery compartment screw ¼ turn anti-clockwise

until the slot aligns with the open padlock symbol, remove the battery cover

and the old batteries.

2. Insert new batteries observing the correct polarity and direction by referring

to the symbols moulded into the battery compartment housing.

3. Check that the battery compartment seal is clean and undamaged.

4. Replace the battery compartment cover and lock into place by rotating the

battery compartment screw ¼ turn clockwise until the slot aligns with the

closed padlock symbol.

Notes on battery life and replacement:

• Use only new or fully recharged batteries

• Do not mix different types of battery.

• Generally, fresh alkaline batteries will have more power and capacity when

compared to rechargeable batteries.

• Significant use of the backlighting and torch will considerably reduce the

battery life.

• It is recommended that the batteries are removed from the RemoteVision if

it is not going to be used for an extended period.