Specifications

24 |
Setup | Triton Operator Manual
Manual source selection
If more than one source is available for an item, the preferred source may be selected
manually. As an example, the following illustrations show how the compass source is
changed.
Select the preferred data source. The selected source will be indicated by a tick in the check
box.
Device list
Shows a list of devices connected to the Network.
Selecting a device from the list will show you an information pane with details of that device.
Some devices such as an RC42 compass store their confi guration, calibration and off set data
in their own memory and not in the display memory. For devices of this type you can check
the data information, confi gure and calibrate the device by selecting Options.
Data
The data list shows the data type that the device is transmitting.
Con gure
Instance
Enter a number to diff erentiate between instances of the same device.
O set
Certain devices will let you enter an off set value to compensate for the position of the sensor
or variation of sensor data.
 Note: Some devices can be confi gured further. If a device transmits other data it may be
shown on this page also.
Calibrate
For compass sensors only, once installed you will need to calibrate the device
Select Calibrate and follow the instructions on the display.