Specifications

36 |
Autopilot| Triton Operator Manual
Pilot Controller
Keys
The Pilot controller is operated by 7 keys, these are used to operate the pilot and adjust pilot
parameters.
Connectors
The Pilot controller is equipped with 1 Network connector at the rear.
Network
The pilot controller can be connected at any point on the network.
Keys Function
Mode: Changes the Pilot mode.
When in Auto mode pressing the mode key will change the Pilot to
Wind mode. A long key press will change to Navigation mode which
will require confi rmation via the display before it is engaged.
Off : Disengages the autopilot. Places the autopilot into Standby mode.
Left 1: Adjust the set course or wind angle 1 degree / steer to Port in
Non follow up mode. When pressed in Standby mode this will enter the
Pilot into Non Follow Up mode.
Right 1: Adjust the set course or wind angle 1 degree / steer to
Starboard in Non follow up mode. When pressed in Standby mode this
will enter the Pilot into Non Follow Up mode.
Left 10: Adjust the set course or wind angle 10 degrees / steer to Port in
Non follow up mode. When pressed in Standby mode this will enter the
Pilot into Non Follow Up mode.
Right 10: Adjust the set course or wind angle 10 degree / steer to
Starboard in Non follow up mode. When pressed in Standby mode this
will enter the Pilot into Non Follow Up mode.
Auto: Engage the autopilot / Acknowledge tack/gybe or navigation
course change.