Specifications

42 |
Autopilot| Triton Operator Manual
Tack & Gybe in wind mode
To tack or gybe in wind mode press both 1º course keys on the Pilot controller.
When you enter a command to tack in wind mode a pop up will appear on screen asking you
to confi rm the desired action. Press ‘Enter’ to accept.
Pressing ‘Enter’ on the display or ‘Auto’ on the Pilot controller will activate the tack/gybe
function and the boat will start turning to the opposite wind angle.
 Note: To cancel the tack/gybe request, press the ‘Off ’ key on the Pilot controller or select
cancel using the display. If neither Tack or Cancel is selected the tack/gybe pop up will close
after 10 seconds and return to the Pilot display and the requested tack/gybe will not be
initiated.
 Note: The Pilot will add a 5 degree bear away on the new wind angle until the boat has
completed the tack. When the target boat is up to speed on the new tack the wind angle will
revert to mirror the previous tack.
Non follow up mode
Whilst in Standby mode, pressing any of the port or starboard keys will move the rudder to
your desired angle and change the pilot mode to Non Follow Up.
 Note: The pilot will remain in Non Follow Up mode until it is turned off or a new mode is
selected.
Navigation mode (Steer to waypoint)
Navigation mode will require a compatible chart plotter connected to the network for it to be
an available mode. Once Navigation mode is selected it will steer the autopilot to the active
waypoint on the chartplotter.
Long press the ‘Mode’ key until the Nav mode symbol is visible in the mode fi eld on the
display.
 Note: When navigation steer mode is selected a pop up message will appear. You will need