Installation manual

| 5

V90 Installation Manual

RF emissions notice

This equipment complies with FCC radiation exposure limits set

forth for an uncontrolled environment. This device’s antenna must

be installed in accordance with provided instructions; and it must

be operated with minimum 96 cm spacing between the antennas

and all person’s body (excluding extremities of hands, wrist and feet)

during operation. Further, this transmitter must not be co-located or

operated in conjunction with any other antenna or transmitter.

FCC statement

This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) this device may

not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause

undesired operation.

¼ Note: This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a normal installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment oﬀ and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an output on a circuit diﬀerent from

that to which the receiver is connected.

• Consult the dealer or an experienced technician for help.

• A shielded cable must be used when connecting a peripheral to the

serial ports.