Instruction Manual

6. OPERATION PROCEDURES

6.1 . STAND-ALONE OPERATION

When using the power supply in stand-alone mode, simply

operate by manipulation of the panel switches and

adjustment knobs as needed.

However, be sure that MASTER / SLAVE switch is set to

MASTER position.

6.2. SERIAL CONNECTION

Two or more units of the power supply can be hooked up in

series to achieve higher output voltage. The resulted output

will be sum of the outputs of the individual units. In this

situation, however, care must be taken that the voltage of

neither of the terminals with respect to the chassis GND

exceed the ground proof voltage of + 180V

• SINGLE VOLTAGE CONNECTION

For connection as shown in FIG.6.1, the output voltage

will be the sum of individual supplies and output

current will be limited to within the value specified for

a single unit whichever is lower. For positive ground

terminal to output positive point and for negative

ground system, hook-up the ground terminal to the

negative output point.

• PLUS / MINUS CONNECTION

For connection as shown in FIG.6.2 where the intermediate

point is hooked up to ground, the configuration can be used as

Plus / Minus power supply.

FIG. 6.1

FIG. 6.2