Manual

101
Cursor Functions
Toggle the button to enter the Cursor menu.
There are three cursor modes available: Manual, Track, and Auto.
To disable cursors, set Mode to Off.
Manual Cursor Mode
Manual cursor mode allows users to set either horizontal or vertical cursors
to make measurements from a selected signal source.
From the Cursor menu, set Mode to Manual. Select the Type of cursor for
the measurement, and select Source.
To adjust Cursor A, select it with to that it’s highlighted, then use
the and arrow keys to adjust its position. Do the same
to adjust Cursor B by selecting it with .
Note: MATH, REFA, and REFB are not selectable as Source unless they are
enabled. Refer to “3.4 Scope Menu” to enable them.
Table 41 - Manual Cursor Menu
Menu
Option
Setting
Description
Mode
Manual
Set to manual cursor mode.
Type
Voltage
Use cursors to measure voltage
parameters.
Time
Use cursors to measure time parameters.
Source
CH1, CH2,
Choose the signal source to measure with