Manual

63
Ref A/Ref B
On
Off
Toggles displaying the reference waveform.
Note: Under Source, CH1 Off and CH2 Off will be displayed if both channel
1 and 2 are turned Off.
Saving a Reference Waveform
Follow the steps below to save a reference waveform.
1. Setup and adjust all parameters of the waveform exactly as you
want saved from channel 1 or channel 2.
2. Go into the Ref menu by pressing and .
3. Under Source, select CH1 or CH2 as the waveform you want to save.
4. You can save two reference waveforms, therefore select REF A or
REF B by toggling .
5. Press to select Save and now the reference waveform is
saved.
6. To display the waveform, toggle to turn On or Off. The
below screenshot displays both REF A and REF B copied from
channel 1 and channel 2. REF A is in red and REF B is in purple.
Figure 33 - Reference Waveforms Display