Manual

100
Manual Mode
Table 32 - Manual Cursor Function Menu
Option
Setting
Instruction
Cursor
Mode
Manual
In this menu, set the manual
cursor measure.
Type
Voltage
Time
Use cursor to measure voltage
parameters.
Use cursor to measure time
parameters.
Source
CH1
CH2
MATH/FFT
REFA
REFB
Select input signal channel.
Cur A
Select this option, turn the
“Universal” knob to adjust
cursor A.
Cur B
Select this option, turn the
“Universal” knob to adjust
cursor B.
In this mode, the screen displays two horizontal parallel cursors or vertical
parallel cursors to measure voltage or time. You can move the cursor by
turning the “Universal” knob. Before using cursors, you should make sure
that you have set the signal source as the channel for measuring.
• Voltage Cursor: Voltage cursors appear as horizontal lines on
the display and measure the vertical parameters.
• Time Cursor: Time cursors appear as vertical lines on the
display and measure the horizontal parameters.
• Cursor Moving: Use the “Universal” knob to move cursor 1 and
cursor 2. They will be moved when the corresponding cursor
options are selected, and the cursor value will display on the
bottom left and top left of the screen when you move the cursor.
To do manual cursor measurements, follow these steps: