Instruction Manual

ManualsBrandsB&K Precision ManualsGenerators4034 - Datasheet

The 4033 and 4034 are high performance pro-

grammable pulse generators for testing digital

systems and circuits based on TTL, CMOS, or

ECL technologies. Both instruments generate

clean and accurate pulses at up to 6 digits reso-

lution with a repetition rate up to 50 MHz, vari-

able pulse widths from 10 ns to 10 s, and pulse

delays from 0 ns to 10 s. Output levels are

adjustable from -10 V to +10 V, with pulse

amplitudes settable from 0.1 Vpp to 10 Vpp into

a 50 ohm load. All parameters, modes, and

functions are programmable via the front panel

or remote control commands. Additionally, the

pulse generators provide selectable complemen-

tary pulse and double pulse generation in contin-

uous, triggered, gated, and counted burst

modes.

50 MHz Programmable Pulse Generators

Models 4033 & 4034

Description Features & Benefits

Applications

Data Sheet

wwwwww..bbkk pprreecciissiioonn..ccoomm

■ Repetition rate of 0.1 Hz to 50 MHz

■ Flexible trigger modes: Continuous, Triggered

(internal, external, manual), Gated Burst and

External Width

■ Pulse width programmable from 10 ns to 10 s

■ Transition times (rise and fall times) variable

from 6 ns to 100 ms

■ Programmable delay and double pulse

■ Predefined amplitude levels for ECL, TTL, and

CMOS signals

■ Store up to 99 different test setups with auto

retention of last power down setup

■ 10 Vpp into 50 ohm output

■ Closed case calibration

■ Programmable via GPIB and RS-232

■ SCPI compatible

■ Three year warranty

■ Automatic Test Equipment (ATE)

■ Avionics and radar testing

■ Switching power supply testing

■ Characterization of active components

Dual-Channel Model 4034

■ Both channels offer full functionality and all

parameters such as pulse width and transition

time can be set independently

■ Synchronize both channels with the push of a

button

■ Saves cost and bench space

Technical data subject to change

Summary of content (3 pages)

PAGE 1
Data Sheet 50 MHz Programmable Pulse Generators Models 4033 & 4034 Dual-Channel Model 4034 Description Features & Benefits The 4033 and 4034 are high performance programmable pulse generators for testing digital systems and circuits based on TTL, CMOS, or ECL technologies. Both instruments generate clean and accurate pulses at up to 6 digits resolution with a repetition rate up to 50 MHz, variable pulse widths from 10 ns to 10 s, and pulse delays from 0 ns to 10 s.
PAGE 2
50 MHz Programmable Pulse Generators Models 4033 & 4034 Industry Leading Performance External Width Variable Transitions Straightforward User Interface In the external width pulse mode, pulse period and width are determined by an externally applied signal. The pulse generator then applies transition and level parameters to this signal in order to generate the pulse.
PAGE 3
50 MHz Programmable Pulse Generators Models 4033 & 4034 Specifications The specifications describe the instrument performance after 30 minutes warm-up period into a 50 Ω load. All timing characteristics are measured at 50% of amplitude with fastest edges. Mode ls 4033 4 03 4 CHANNELS 1 2 FREQUENCY T RANS IT IO N T IME S 0.1 Hz to 50 MHz T I M I NG C H A R A C T E R I S T I C S Range <6 ns to 100 ms variable.