Manual

59
4.12.2 OUTPut Subsystem
The Output Subsystem controls characteristics of the source’s output. The OUTPut command controls
whether the output is ON or OFF.
COMMAND TYPE: Setting or Query
SETTING
Syntax: [:OUTPut]:STATe<ws><Boolean>
Arguments:
Type: Boolean
Examples: :OUTP:STAT ON
:OUTP OFF
QUERY
Syntax: :OUTPut[:STATe]?
Response: 0 | 1
MODEL 4034 ONLY:
To control output of channel 2, change the subsystem from :OUTP to :OUTP2. For example, to
turn on output of channel, send command :OUTP2:STAT ON.
4.12.3 Trigger Subsystem
The Trigger Subsystem is used to control the waveform triggering. It is not all SCPI compatible. The
command structure is as follows:
:TRIGger
:MODE CONTinuous | TRIGger | GATE | BURSt
:BURSt <NRf>
:SOURce <MANual> | INTernal | EXTernal | BUS
:TIMer <NRf>
:LEVel <NRf>
:DELay <NRf>
:SLOPe POSitive | NEGative
MODEL 4034 ONLY:
To control the trigger mode of channel 2, change the subsystem from :TRIG to :TRIG2. For
example, to check trigger mode of channel 2, send the command :TRIG2:MODE?
4.12.3.1 Trigger Mode
This command is used to set the trigger mode. It is not a standard SCPI command.
COMMAND TYPE: Setting or Query
SETTING
Syntax: :TRIGger:MODE<ws><option>
Arguments:
Type: Character
Options: CONTinuous
TRIGger
GATE