User Manual
CHAPTER 3. OPERATION 12
Figure 3.2: Entering A Numeric Value
3.2.1 Numeric Notations
When entering a parameter using the numeric keypad entry is completed by selecting the units from the
on-screen so-keys as shown in Figure 3.3. Some parameters have fewer unit options than others. The list of all
options and their descriptions is as follows:
x1 Denotes x1 unit prefix of the entered value.
u Denotes micro (x10
−6
) unit prefix of the entered value.
m Denotes milli (x10
−3
) unit prefix of the entered value.
k Denotes kilo (x10
+3
) unit prefix of the entered value.
Other parameters (like “Delay” in Measurement Setup) may be changed by the keypad and another set of
on-screen so-keys. Table 3.1 describes these keys and their function.
Figure 3.3: Numeric Notations
Note: Baudrate seings in SYSTEM SETUP menu is an exception, where INCR+ and DECR– op-
tions are available to select between the following discrete rates: 9600, 19200, 28800, 38400, 96000,
115200.