User Manual

CHAPTER 3. OPERATION 16
3.3.2 Default Seings
Tables 3.4,3.5,3.6,3.7 list the default instrument seings.
Parameter Default Value
FUNC R-V
SPEED MED
TRIG INT
DELAY 0 ms
Vm ON
DEV_A OFF
DEV_B OFF
RNG_V AUTO
RNG_R AUTO
AVG 1
LINE 60 Hz
Im ON
REF_A 0
REF_B 0
Table 3.4: Measurement Defaults
Parameter Default Value
Mode ABS
COMPA ON
COMPB ON
NOMA 0
NOMB 0
HIGHA (all bins) 0
LOWA (all bins) 0
HIGHB (all bins) 0
LOWB (all bins) 0
Table 3.5: BIN Setup default seings
Parameter Default Value
Total 20 s
A MAX 5 kΩ
A MIN 0 µΩ
A Stop1 5 kΩ
A Stop2 -5 kΩ
Interval 1.0 s
B MAX 5 kV
B MIN 0 µV
B Stop1 5 kV
B Stop2 -5 kV
Table 3.6: Trace setup default seings
Parameter Default Value
Key Sound ON
Language English
Password OFF
Bus Mode RS232C
Baud Rate 9600
Bus ADDR 8
Table 3.7: System setup default seings
3.4 Short Correction
Short correction helps measurement accuracy by eliminating the measured short compensation value to the
primary and secondary measurements.
1. Connect the TLKB1 Kelvin clips to the input terminals of the instrument securely.
2. Clip both clips together to create a short. Figure 3.8
3. Select SHORT from the so menu, and the display will show “Shorting .. . ”.