User Manual
CHAPTER 3. OPERATION 21
3.7 Main Measurement Display
The measurement display is accessed by pressing the buon. Shown are the selected measurements as well
as the voltage measured and current sourced to make the measurements.
The FUNC, SPEED, RNG_V, and RNG_R parameters are also configurable from this screen. Use the arrow keys
to select them, and the keypad and so menu function keys to change them. Refer to Table 3.8 for a detailed
description.
Figure 3.9: Measurement Display
Figure 3.10: Measurement Setup Function Keys
Note: When the Trigger parameter in Measurement Setup is not set to INT (internal trigger), the measurement
display will not show primary and secondary measurement until a triggered.
When Vm (Measured voltage display) and/or Im (Measured current display) parameters are set to OFF in Measure-
ment Setup, “OFF” is shown beside Vm and/or Im.
3.8 Measurement Setup
Access the Measurement setup display (Figure 3.11) by pressing the buon, and then press the function
key corresponding to MEAS SETUP from the so menu. All measurement parameters in this menu are