User Manual

CHAPTER 3. OPERATION 28
Figure 3.14: BIN Sorting - BIN1 Pass
Figure 3.15: BIN Sorting - Fail
Figure 3.16: Compare Test Pass
1. Go to the BIN Display, and set Mode to Compare.
2. Configure all other parameters as necessary, see Table 3.10.
3. Connect the TLKB1 kelvin clips to the DUT.
When measurements pass, the display will show IN, as shown in Figure 3.16. The front panel pass/fail indicator
will illuminate green .
When the measured value fails, the display will show LO or HI. The front panel pass/fail indicator will
illuminate red .