User Manual
CHAPTER 3. OPERATION 29
LO measured value is below the “Load BIN” range seings.
HI measured value is above the “Load BIN” range seings.
Figure 3.17: Compare Test - Below Limits
Figure 3.18: Compare Test - Above Limits
3.9.4 BIN Tools
The BIN tools menu is accessed from the BIN Display by pressing the and selecting BIN DISP. Then press
right arrow key twice to select TOOLS. If the current selection is on a parameter, then use any of the arrow
keys to navigate to TOOLS.
Figure 3.19: BIN Tools Menu
3.9.5 BIN function setup
Press the buon, and then press the function key corresponding to BIN SETUP to open the BIN SETUP
menu; Figure 3.20 will be displayed. Use the arrow keys to select each parameter, and the function keys to make
changes. Enter numeric parameters (i.e. nominal and high and low limits) using the keypad, and the function keys
to select the units. See Table 3.11 for parameter and option details in this menu.