User Manual

CHAPTER 3. OPERATION 32
Figure 3.21: Trace Setup Display
function keys to make changes. Parameters that require entering a numeric value must use the keypad, and the
function keys to select the units.
The below table explains the parameters and their options/range.
Parameter On-screen Label Description/Options
Total Time Total
Sets the total time to run the trace function. The test will com-
plete when this time has elapsed.
Valid Range: 1 - 99999 seconds
Sampling Interval Interval
Sets the time between each primary and secondary measure-
ment captured and traced.
Valid Range: 1.0 - 86400.0 seconds
Primary Measurement
Trace Scale Maximum
A MAX
Sets the maximum range of the scale of the trace for the pri-
mary measurement.
Valid Range: 0 - 99999k
Primary Measurement
Trace Scale Minimum
A MIN
Sets the minimum range of the scale of the trace for the primary
measurement.
Valid Range: 0 - 99999k
Secondary Measurement
Trace Scale Maximum
B MAX
Sets the maximum range of the scale of the trace for the sec-
ondary measurement.
Valid Range: 0 - 99999k
Secondary Measurement
Trace Scale Minimum
B MIN
Sets the minimum range of the scale of the trace for the sec-
ondary measurement.
Valid Range: 0 - 99999k
Primary Measurement
Upper Limit
A Stop 1
Sets the upper limit value as a stop condition of the test. If the
primary measured value exceeds this for 2 consecutive samples,
the test will stop.
Valid Range: Dependent on the measurement range of the se-
lected primary function.
Primary Measurement
Lower Limit
A Stop 2
Sets the lower limit value as a stop condition of the test. If the
primary measured value exceeds this for 2 consecutive samples,
the test will stop.
Valid Range: Dependent on the measurement range of the se-
lected primary function.