User Manual

CHAPTER 3. OPERATION 34
Figure 3.23: Trace Tools Display
Parameter On-screen Label Description/Options
Initiate or stop trace
test
SCAN START
(SCAN STOP)
Starts or stops the trace test.
Options: START, STOP
Trace Display TRACE
Selects the trace to display.
Valid Range: A, B, A+B
A The primary measurement trace.
B The secondary measurement trace.
Cursor Display CURSOR
Enables/disables the cursor. When enabled, the cursor can be
controlled using the arrow keys. The cursor is used to
view the primary and secondary measurements, and the times-
tamp of any measured points on the trace.
Maximum/Minimum
Value Display
Max-Min
Enables/disables the display of the maximum and minimum
values of both the primary and secondary measurement traces.
Options: ON, OFF
Table 3.13: Trace Display Tools Parameters
• Press CURSOR to see the values of a measured point on the trace. Using the keys to move the
cursor along the trace.
• The maximum and minimum values of the primary and secondary measurements of the trace may also be
displayed by pressing Max-Min to ON.
3.11 Statistical Measurement
The instrument can calculate statistical measurements, which are accessed by pressing and selecting
STATIS DISP from the so menu.
Before performing a statistical calculation, some parameters must be configured first. They are grouped together
on display the box highlighted in cyan like this, parameter . See Figure 3.26. Use the arrow keys to select each
parameter, and the function keys to make changes. Parameters requiring entering a numeric values are entered