User Manual

CHAPTER 3. OPERATION 38
Hi(num) Total number times the measurement results exceed the upper limit value Hi[].
Lo(num) Total number times the measurement results are below the lower limit value Lo[].
In(num) Total number of times the measurement result is within the upper and lower limits.
Max Displays the maximum measurement value from all the captured measurement samples.
MaxIndex Displays the index from the internal buer containing all the captured measurement samples, in
which contains the maximum measurement value.
Min Displays the minimum measurement value from all the captured measurement samples.
MinIndex Displays the index from the internal buer containing all the captured measurement samples, in
which contains the minimum measurement value.
3.11.1 Statistical Measurement Operation
To operate the statistical measurement function, press the buon and select STATIS DISP from the so
menu. Press right arrow key twice to select TOOLS. If the current selection is on a parameter, then use any of
the arrow keys to navigate to TOOLS.
Figure 3.28: Statistics Tools Menu
In the TOOLS menu, there are two options: Statis START, TRIG.
Operation steps
1. Select the primary and secondary measurement parameters to perform the calculation. To do this, follow
instructions in Section 3.8, Measurement Setup.
2. Configure all statistical parameters (described in Table 3.14) as necessary.
3. From the TOOLS menu, press the function key corresponding to Statis START so key to begin the
calculation.
• If the trigger source is not set to internal trigger (INT), select TRIG from the so menu to manually
trigger a single capture of a measurement sample.
• To complete calculation, continue to press TRIG until the message prompt displays “Measurement
Completed”.