User Manual

32
1. From the CONFIG menu, browse and select Ext-Ctrl and press . The following
screen will display:
2. Select the third item V-P or R-P so that it is blinking. Use the keys to change
between V-P or R-P.
V-P – Use external DC voltage source for programming the output.
R-P – Use external resistance for programming the output.
3. Press when finished making the selection.
4. Press several times to exit the menu.
Enable/Disable External Analog Control
If external analog control is not used, it must be disabled before normal front panel operation
can resume. Follow the steps below to enable or disable external analog control.
1. From the CONFIG menu, browse and select Ext-Ctrl and press . The following
screen will display:
2. Select Off and press . This will disable external analog control. To enable, select
Off and press the down arrow key to select On. Press after selection.
3. When finished, press several times to exit the menu.
Ext – Ctrl Setup
10v-M 10v/10k-P V-P Off
Ext – Ctrl Setup
10v-M 10v/10k-P V-P Off