User Manual

25
function is widely used for startup and shutdown current impact tests and various rectifier
performance tests.
When the (Shift) and (Phase) button are pressed, the following screen will be shown.
Use the numeric keys to set the start phase angle and press
EnterEnter
to confirm the start phase
setting. The following screen will be shown next.
Use the numeric keys to set the stop phase angle and press
EnterEnter
to confirm the stop phase
setting.
3.3 SYSTEM Menu
All setup procedures and settings explained in this section can be accessed from the SYSTEM
menu. To access this menu, press (Shift) and press (Menu) . When SYSTEM is
blinking, press
EnterEnter
.
Restore Factory Default Settings
All instrument settings can be reset back to their factory default values by doing the following:
300.0V
0.0mA
Stop
OFF Auto
Phase = 0.0°
50.0
0.1 s
300.0V
0.0mA
Start
OFF Auto
Phase = 90.0°
50.0
0.1 s