User Manual

Figure 3.10 – Parallel Connection Diagram

*The power supplies must all be of the same model for parallel

operation to function properly. If you want to connect more than 10

units in parallel, we recommend contacting us at

www.bkprecision.com for further assistance.

After wiring is complete, configure one of the supplies as the Master

and the other slaves (i.e. SLAVE 1 – SLAVE 49). After one of the supplies

is configured to be the Master, it will start searching for all Slaves that

are connected to the Master. To operate correctly, the user must set up

LOAD

Bus

RJ45 Cable