User Manual

1. From the SYSTEM menu, select Communication and press .

2. Press button three times until RS-232 is blinking and press

to configure the settings for RS-232 remote

communication. The following display will be shown:

3. Use keys to select between each serial settings and

press to configure the corresponding settings.

4. To change the baud rate or any of the parameter settings, use

the rotary dial.

5. Press to save each setting and the display will return to the

RS232 menu.

6. Below lists the options that can be changed for each setting:

Baud rate: 9600, 19200, 38400, 57600

Parity/Data bits: None/8 bits, Even/8 bits, Odd/8 bits, Even/7

bits, Odd/7 bits

Stop bit: 1, 2

Flow control: None*

Note: The default is 9600, None/8 bits, 1.

* The RS-232 interface does not have flow control mechanism.

The programmer should be aware of this limitation and notice

the command process time of the power supply. If the remote

commands are sent too fast to the power supply, the internal

buffer may overrun and cause a communication error.