User manual

value by connecting a resistance value of 0-5 kΩ (0-5 V / 0-5 kΩ mode)

or 0-10 kΩ (0-10 V / 0-10 kΩ mode) between Pin 9 and Pin 22 as shown

below.

Figure 3.5 - Analog Voltage Programming Diagram (Resistor Mode)

Current Program

This function is able to program the current output by connecting an

external DC voltage (voltage mode) or an external resistor (resistor

mode) to Pin 10. For this function to be enabled, the output control

must be in analog mode. The external voltage range or resistor range

used to control the full scale of the output voltage can be selected

between 0-5 V / 0-5 kΩ and 0-10 V / 0-10 kΩ range. Follow the steps

below to configure the voltage program.

1. Press the button and press the button one time until

CONFIG is blinking and press .

2. Press button three times until EXTCTRL is blinking and

press .

3. Press button two times to select CURRENT and Press .

4. Use the rotary knob to select EXT-V (external voltage) or EXT-

R(external resistance) option and press . To have front

panel control, select FRONT.

5. Use the keys to select PROG RNG (program range)

and press .

0 – 5 kΩ

0 – 10 kΩ