Operating instructions
System Components OI: BK MIKRO LIN.B
Page 16 of 30 Rev. 2.02 dated 31.05.2007
2.3 Connection cable
Control unit and scanner are connected by a 6-wire PUR-cable:
• Small circular connector to DIN 45322 at the control unit end.
• Molded plug at the scanner end.
• Length 5 m, can be extended to a maximum length of approximately 25 m
with extension cables.
Pin configuration (at the control unit end)
Small circular connector to DIN 45322, 6 pin
1 wh white
2 br brown
3 gn green
4 ye yellow
5 gr gray
6 pi pink
Fig. 2-12: Connection cable – Pin configuration
Note:
• To increase the operational life of this cable, it should not be subject to more
than a minimum amount of movement during operating cycles.
• If this plug needs to be removed during fitting, please ensure that this pin
configuration is followed on reassembly.
gr
ye
gn
br
wh
pi
3
1
2
6
5
4