Operating instructions

General Notice OI: BK MIKRO LIN.B
- II - Rev. 2.02 dated 31.5.2007
Qualification of personnel
Only qualified personnel may carry out the following activities on the control system:
installation, commissioning, operation, maintenance.
Qualified persons in accordance with the safety guidelines are defined as persons who
are authorized to commission, to ground, and to tag circuits, equipment, and systems in
accordance with established safety practices and standards.
Disclaimer of liability
We have checked the contents of this document for agreement with the hardware and software
described. Since deviations cannot be precluded entirely, we cannot guarantee full agreement.
However, the data in this manual are reviewed regularly and any necessary corrections included
in subsequent editions. Suggestions for improvement are welcomed.
EEC directive EMC 89/336/EEC
The following applies to BK MIKRO control system:
Products which carry the CE symbol meet the requirements of the EEC directive
89/336/EEC on electromagnetic compatibility.
The EEC declarations of conformity and the related documentation will be maintained at the
following address for inspection by the responsible officials in accordance with article 10(1)
of the above stated EEC directive:
MSC Tuttlingen GmbH
Rudolf-Diesel-Straße 17
78532 Tuttlingen
BK MIKRO LIN.B corresponds the specification of UL 508.
Areas of use
Control systems of the BK MIKRO series meet the applicable, harmonized, European standards
for the respective area of applications.
Fitting conditions
The fitting conditions and safety notes in the operating instructions must be adhered to when
commissioning and operating the devices.
Copyright
These operating instructions are intended for the operator and the operator’s personnel only.
This document and its contents may not be disclosed to third parties, either in full or in part,
by reproduction, transmission or any other means without express written authority.
Non-compliance may lead to prosecution under criminal law.