Operating instructions

System Components OI: BK MIKRO 7

Page 14 of 32 Rev. 2.01 dated 05.02.2007

2.3 Connection cable

Control unit and scanner are connected by a 8-wire PUR-cable:

 6 pin small circular connector to DIN 45322 at the control unit end.

 8 pin molded plug at the scanner end.

 Length 5 m, can be extended to a maximum length of approximately

25 m with extension cables.

Pin configuration (at the control unit end)

Small circular connector to DIN 45322, 6 pin

1 wh

white

2 br brown

3 gn green

4 ye yellow

5 gr gray

6 pi pink

Fig. 2-9: Connection cable – Pin configuration

Note:

To increase the operational life of this cable, it should not be subject to more than

a minimum amount of movement during operating cycles.

If this plug needs to be removed during fitting, please ensure that this pin

configuration is followed on reassembly.