User manual

11
Video Output Connection - Component Video Record Output
The component video record output connection on the receiver standardly carries High Definition video. However, for use with recording
purposes, B&K supports Component, Composite or S-Video on this output. While set to RECORD OUT, any selected video source on
the receiver is scaled to Composite or S-Video as set under System Video setup. Note: The system setup menu will NOT be displayed
on the this output during record mode operation.
During standard video processing, the only video outputs available are
HDMI and/or Component video. If your monitor or television does not have support for these connections, please con-
tact your local authorized B&K dealer.
Video Output Connection - Component Video
The component video output connection on the receiver carries High Definition video to
your television or monitor. To connect an component video output from the B&K, connect
the three RCA component video cables to the corresponding component video outputs on
the B&K. Then connect the other ends of the cables into the corresponding component
video inputs on your television or monitor. Shown is the component video output on the
B&K going to the component video input on a monitor.
Video Output Connection - HDMI
The HDMI output connection on the receiver carries High Definition video to your television or monitor. To connect an HDMI video out-
put from the B&K, connect the HDMI cable to the HDMI output on the B&K. Then connect the other end of the cable into the correspon-
ding HDMI input on your television or monitor. Shown is the HDMI output on the B&K going to
the HDMI input on a monitor.
Video Outputs - Hardware Connections