User Guide

7. CT 2 OUT - One 1/8" mono mini connector. To be used with an IR emitter for control of a

CT Receiver. This output is a sum of IR Data from CT-1, CT-3, Home Theater and Chain IN.

8. Home Theater Routing -On/Off DIP switches determine which of the nine IR FLASHER

outputs will emit IR to a shared source from the HOME THEATER IR inputs. These DIP

switches will allow IR Data from the Home Theater to control certain shared sources.

9. HOME THEATER IN / OUT - Two 1/8" mono mini connectors.

IN - IR input from a Home Theater (same as Home Theater Sensor IR-IN).

OUT - IR output to a Home Theater product. This output is a sum of all

IR Data coming into

the CT-1 (Global Output). This output can also be used as a global system IR output.

10. Flasher Out - Nine 1/8" mono mini connectors. Each output is connected to a shared source

using an IR emitter.

11. CHAIN IN - One 1/8" mono mini connector only used when chaining multiple CT-1s together.

CHAIN IN receives IR data from the next CT-1 in a chain.

12. CT 1 Flasher IN - Nine 1/8" mini connectors. One CT Receiver is connected by nine 1/8” mini

jack interconnects. Each interconnect should be connected corresponding to the IR output on

the CT Receiver back panel. i.e. IR OUT 1 connects to Flasher IN 1, etc.

13. CT 1 OUT - One 1/8" mono mini connector. To be used with an IR emitter for control of a

CT Receiver. This output is a sum of IR Data from CT-2, CT-3, Home Theater and Chain IN.

Input / Output Diagram

X = IR In O = IR Out

CT-1 Back Panel