User Guide

Source Emitter Connections

Up to nine sources can be shared in any

CT system, not including the dedicated

inputs. Source control is provide by

installing an IR emitter to the front panel

of each source. Each source is

connected to the CT-1 according to

which CT input it is located on. For

example, if the DVD player is located on

IN 1 on the CT600, then its IR emitter

should be connected to Flasher OUT 1

on the CT-1 and so on.

CT-1 Power Connection - 12VDC

Power can be supplied to the CT-1 through any 12VDC (30mA -100mA) power supply. To simplify installation,

utilize the 12VDC power supply from one of the CT Receivers in the rack. Additionally connect the RS-232

transmit from the master CT Receiver for potential RS-232 communication to a theater receiver or

preamplifier. If RS-232 control is not desired, then the RS-232 portion does not need to be connected.

If RS-232 is not needed, or if all zone keypad ports are being used, then use the 12VDC supply from the

common control.

CT-1 Basic Connection

Source 1

Source 2

Source 3