Service manual

PULL DOWN MENUS
4-2
Month 2000
Part No. 001-2008-104
Figure 4-4 EDIT PROGRAMMING FLOWCHART
Repeater Number
Channel Number
System Key
System Priority Type
Status Repeater
Status Free
Stand-alone
Standby Repeater
CWID Time
CWID Message
Busy Hang Type
Busy Hang Time
Voter Enable
Voter Baud Rate
ID Validator
Local Mic ID
Test Mode ID
Default
Repeater Number
Input Alarms
Output Alarms
Cross Reference
Input Type Selection
Output Type Selection
Select Repeater
Alarm Configuration
EDIT
Setup Parameters F4
TELCO Network Type
Alarm Cross Reference Selection
Delete Repeater
Repeater Type
Power Source
RF Power Level
Multi-Net
LTR
Universal Station
Frequency Band
Power Level
75W
800 MHz
800 MHz (-12.5 kHz)
900 MHz
Paging
Repeater Type
IAC Type
8 I/O IAC
4 I/O IAC
175W
4.2.4 PRINT REPEATER CONFIGURATION
Select the destination for the configurations.
Printer - Prints to printer connected to PC.
File - Writes printable text to selected filename.
Select which repeater data will be printed.
• All Repeaters
Prints the data for all valid repeaters.
• Single Repeater
Print the data for the entered repeater number.
NOTE: A list of valid repeaters can be seen under the
Edit-Select Repeater menu selection.
4.2.5 DOS SHELL
Temporarily suspends the program and returns to
DOS. Directories and other DOS commands can be
performed. To return to the program from DOS, type
EXIT and press Enter.
4.2.6 QUIT (ALT X)
Exits the repeater program and returns to DOS.
Be sure all files are saved before exiting the program.
4.3 EDIT
Figure 4-5 EDIT MENU
This menu is used to create new files and set or
change the repeater operating parameters. The file-
name for the repeaters in this file is shown in the lower
left corner of the screen.