Manualshelf

User's Manual

ManualsBrandsB-LINK ELECTRONIC ManualsElectronicswifi module
12345
⠜ᴀ
Appendix A FCC
A.1 FCC statement in User's Manual (for class B)
"Federal Communications Commission (FCC) Statement This Equipment has been tested
and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
z Reorient or relocate the receiving antenna.
z Increase the separation between the equipment and receiver.
z Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
z Consult the dealer or an experienced radio/TV technician for help.
A.2 FCC Statements:
1. This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions:
z This device may not cause harmful interference,
z and This device must accept any interference received, including interference that
may cause undesired operation.
2. This device and its antenna(s) must not be co-located or operating in conjunction with
any other antenna or transmitter.
3. Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.
4. This compliance to FCC radiation exposure limits for an uncontrolled environment, the
minimum of 20 cm separation distance shall be maintained between antenna and body.
The host device must be labelled to display the FCC ID of the module "Contains
FCC ID:X2NBL-LW02-2"