Owners manual

into the bore then install the valve,
aluminum plug, and roll pin in reverse
order of removal. Important: Do Not
dry or wipe parts with cloth rags be-
cause the lint and loose threads can
contaminate the transmission fluid and
result in jambed pressure regulator and
shift valves. Clean valve body and sepa-
rator plate with clean solvent and air
dry.
ASSEMBLY
STEP 9. Heavy Duty and Street;
Check ball placement (See Figs. 6
& 7) Place check balls in the valve body
and case in the positions shown. Use
a dab of grease or petroleum jelly to
hold check balls in position. There are
(3) check balls located in the valve
body and (8) in the case.
STEP 10. Place the new separator
plate gaskets on the separator plate
(See Fig. 8.) Use a dab of grease or
petroleum jelly to help hold the gas-
kets to the plate. The gasket with the ‘C’
cut in it goes next to the case and the
gasket with the ‘V or VB’ cut in it goes
next to the valve body. Make sure no
holes in the separator plate are covered
by the gasket. If your gaskets become
damaged anytime during the installation
of the kit, replace them. Purchase
OEM gaskets for your specific year and
model vehicle.
STEP 11. Heavy Duty Level Only; In-
sert the 3-4 accumulator pin in the case.
Over the pin place the spring and then the
accumulator piston. Use a dab of grease
or petroleum jelly to hold components in
place (See Fig. 9.)
STEP 12. Street Level Only; Insert
the 3-4 accumulator pin in the case. Over
the pin place the Red (3/8") spacer,
spring and accumulator piston. Use a
dab of grease or petroleum jelly to hold
components in place (See Fig. 10.)
STEP 13. With the 3-4 accumulator
components and case check balls in
place, place the separator plate - gas-
ket assembly up to the case followed
by the 1-2 accumulator plate. Carefully
line up the gaskets and install the short
accumulator plate bolt. Tighten bolt
finger tight (Note: When installing valve
body and accumulator housing install
all bolts finger tight first to allow the
separator plate and gaskets to properly
line up before attempting to torque them.
STEP 14. Heavy Duty Level Only;
Place ckeckballs in the 8 locations
marked
3-4 accumulator
Fig. 8. Valve Body Gaskets.
5
Fig. 7. Case Checkball Placement.
Valve body
gasket
Case gasket