Owners manual

Torque 1/4-20 bolts to 8-10 ft-lbs.

Caution do not overtorque bolts!!

Torque M8 thin nuts to 8-10 ft-lbs.

Torque M8 nuts to 15 ft-lbs.

Leave approx. 0.9" of M8 set

screw thread above GTO Trans

after locking down GTO Trans.

ASSEMBLY

STEP 14. Install B&M shifter using (2) 1/4-20 bolts, (2) lock

washers, (2) M8 nuts, (2) M8 thin nuts and (2) M8

washers.

(SEE DIAGRAM BELOW FOR DETAILS)

TOOLS: Screwdriver (flat), Hex Wrench (6mm), thread

adhesive, and wrench (13mm)

NOTE: FAILURE TO USE THREAD ADHESIVE COULD

RESULT IN SHIFTER MALFUNCTION.

STEP 15. Reinstall rubber boot.

NOTE: On some earlier models a black boot was used

which may need some trimming of the opening to

allow for full gear engagement of 1, 3 & 5th gear.

Or you can replace the black boot with the newer

white boot, GM P/N: 92169196.

STEP 16. Install top stick L using (2) 5/16-18 bolts and

thread adhesive.

TOOL: 3/16 Hex and adhesive.

Torque bolts to 26 ft./lbs. (35 N/m)

NOTE: FAILURE TO USE THREAD ADHESIVE COULD

RESULT IN SHIFTER MALFUNCTION.

.9"

M8 NUT

M8 LOCKWASHER

M8 FLAT WASHER

B&M BASE

M8 THIN NUT

GTO TRANS

GTO TRANS GASKET