User's Manual

B&B Electronics, Inc. APPN-TT551 Databook
30
gain supérieur au gain maximum indiqué pour ce type, sont strictement interdites
pour une utilisation avec cet appareil.
The following is a list of the Antenna’s approved to work with this transmitter,
please contact your B&B representative if you have any questions.
MFG P/N
Max. Gain 2.4G
(dBi)
Impedance (Ω
ΩΩ
Ω)
Taoglas GW.71.5153 3.8 50
The installer of this radio equipment must ensure that the antenna is located or
pointed such that it does not emit RF field in excess of Health Canada limits for
the general population; consult Safety Code 6, obtainable from Health Canada’s
website www.hc-sc.gc.ca.
This Device complies with Industry Canada license-exempt RSS
standard(s).Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement.
11.4 FCC/IC Modular Approval
This document describes the Airborne FCC modular approval and the guidelines
for use as outlined in FCC Public Notice (DA 00-1407).
The APPN-TT551 is covered by the following modular grants:
Table 20 - Modular Grant Numbers
Country Standard
Grant
North America (US)
FCC Part 15
Sec. 15.107, 15.109, 15.207, 15.209, 15.247
Modular Approval
F4AAPPN551
Canada
RSS 210
Modular Approval
3913A-APPN551
By providing FCC modular approval on the Airborne module, the customers are
relieved of any need to perform FCC part15 subpart C Intentional Radiator
testing and certification, except where they wish to use an antenna that is not
already certified.
B&B supports a group of pre-approved antenna; use of one of these antennas
eliminates the need to do any further subpart C testing or certification. If an
antenna is not on the list, it is a simple process to add it to the pre-approved list
without having to complete a full set of emissions testing. Please contact B&B
Technical support for details of our qualification processes.
Please note that as part of the FCC requirements for the use of the modular
approval, the installation of any antenna must require a professional installer.
This is to prevent any non-authorized antenna being used with the radio. There