User's Manual

Print instructions

1. Locate a clean, ﬂat surface near the bar code for printing.

2. Place the nose of the SP400X against the surface. The SP400X should rest at an angle of about 7 degrees from vertical.

3. Move the SP400X straight across the surface.

4. When the print is ﬁnished, the green light will turn off and the SP400X will emit a Hi tone.

CAUTION: Maintain a relaxed wrist and hand posture and use low force when printing.

Printing tips

IMPORTANT:

• Keeptheprinterwheelcontinuouslyincontactwiththeprintsurfacewhileprinting.

• HoldtheSP400Xsothattheangleofthedevicetothesurfaceisapproximately7degrees.

• Donotpushhardonthesurface;lightpressurewillresultinbetterprints,especiallywithsoftpackages.

• Donotrotateyourwrist.Rotatingyourwristwhileprintingcancauseskippingorincompleteprints.

1. Print wheel

SP400X Series - 5. Operate the SP400X