Specifications

SHENZHEN B&T TECHNOLOGY Co., Ltd ZHONGSHAN B&T TECHNOLOGY Co., Ltd

ATTENTION

This device is intended only for OEM integrators under the following conditions: 1) The antenna must be

installed such that 20 cm is maintained between the antenna and users, and

2)This device and its antenna(s) must not be co‐located with any other transmitters except in accordance

with FCC multi‐transmitter product procedures. Referring to the multi‐transmitter policy, multiple

transmitter(s) and module(s) can be operated simultaneously without C2P.

3)For all products market in US, OEM has to limit the Operating Frequency: 2400 ~2500MHz by supplied

firmware programming tool. OEM shall not supply any tool or info to the end‐user regarding to Regulatory

Domain change.

USERS MANUAL OF THE END PRODUCT:

In the user manual of the end product, the end user has to be informed to keep at least 20cm separation

with the antenna while this end product is installed and operated. The end user has to be informed that the

FCC radio‐frequency exposure guidelines for an uncontrolled environment can be satisfied. The end user

has to also be informed that any changes or modifications not expressly approved by the manufacturer

could void the user's authority to operate this equipment.

If the size of the end product is smaller than 8x10cm, then additional FCC part 15.19 statement is required

to be available in the users manual: This device complies with Part 15 of FCC rules. Operation is subject to

the following two conditions:

(1)this device may not cause harmful interference and

(2)this device must accept any interference received, including interference that may cause undesired

operation.

FCC WARNING

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

Any changes or modifications not expressly approved by the party responsible for compliance could void

the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generate, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.