User's Manual

4
ENGLISH
Diagram 4
Battery life indicator
3. Battery charging
The T7 battery will be discharged when you rst
unpack it. To charge the T7 battery follow the steps
described below.
• Select the appropriate regional plug adapter
for the mains outlet socket in your territory and
clip it to the power supply body as illustrated in
Diagram 2.
• Plug the T7 power supply into a mains outlet
socket and connect its output cable to the T7
power input socket. This is illustrated in Diagram
3. If the mains outlet socket incorporates an
isolator, switch it on.
Once the T7 is connected to power its battery will
begin to charge. A full charge from a fully discharged
state will take approximately four hours. It is best
initially to leave T7 connected to power until it is fully
charged although it can be used while it is charging.
T7 will provide audible feedback when it reaches full
battery charge.
When the Standby button is briey pressed (< 3s)
the column of ve indicators on the right-hand side
of T7 will illuminate for short period to indicate the
state of battery charge. The sequence of indicator
illumination depends on the level of charge.
At between 0% and 10% charge the bottom
indicator will ash rapidly with the indicator directly
above blinking quickly and the three indicators
above that blinking at decreasing rates. At between
10% and 20% charge the bottom indicator will
blink quickly and the four indicators above it blink
at decreasing rates. As the battery becomes
fully charged, the indicators will, from bottom to
top, switch from blinking to continual illumination
until, at full charge, the rst four indicators will
be continuously illuminated with only the top one
ashing. As the battery discharges with use, a
similar, reverse sequence of illumination will occur.
The T7 will provide audible feedback when battery
falls below 20% and again when it falls below 10%.
Diagram 4 illustrates all the indicator illumination
sequences for battery charge and discharge levels.
- Simplied diagram required (each LED = 20% of
charge)
Note: You can charge T7 at anytime independent
of battery level.
4. Switching on and off
To switch your T7 on or off press and hold the
Power button for 3 second. T7 will provide audible
feedback as it switches on.
Note: If T7 is unused for more than 10 minutes it
will automatically enter sleep mode. To wake T7
from sleep mode press either the Bluetooth or
power button. An analogue audio signal input or
Bluetooth audio stream will also wake T7. If T7 is
unused for more than 20 minutes it will switch off
automatically.
If T7 has not been previously used or it is not
within range of previously connected Bluetooth
devices when rst switched on, only its analogue
jack input will be operational. See the following
section of this manual for information on connecting
to Bluetooth devices.
Diagram 3
Selecting the appropriate adapter
Diagram 2
Selecting the appropriate adapter
POWER AUX USB RESET
POWER AUX USB RESET
100%
80%
60%
40%
20%