User's Manual

5
ENGLISH
Diagram 5
Bluetooth setup
5. T7 audio inputs
T7 can play audio either wirelessly from a compatible
Bluetooth device or through a wired connection from
a device with an analogue output; a headphone
socket for example. Section 5.1 describes
connection of Bluetooth devices. Section 5.2
describes connection of wired audio devices.
T7 will select between its Bluetooth and wired inputs
automatically although the Bluetooth input has
priority. The following input selection rules apply:
• If T7 is connected via Bluetooth and a plug is
inserted in the analogue input socket, T7 will
switch to the analogue input.
• If T7 is playing audio through its analogue input
and a Bluetooth stream is received or the
Bluetooth button is pressed, the T7 will switch
to the Bluetooth input.
• If T7 is playing audio through its analogue input
and the cable is disconnected T7 will switch
to the Bluetooth input and attempt to connect
to the primary paired source device. See the
following section for more on pairing Bluetooth
devices.
• If T7 is connected via Bluetooth while an
analogue input cable is also connected, an new
analogue audio signal will not automatically
switch T7 to its analogue input.
5.1 Bluetooth connection
To connect your T7 to a Bluetooth enabled audio
device it must rst be “paired” with the device. Once
paired, a Bluetooth device and T7 will “remember”
each other and be able to connect when within
range. To pair a Bluetooth device with your T7 follow
the steps described below. Diagram 5 illustrates the
procedure.
• With T7 switched on, press and hold the
Bluetooth button for 2 seconds. The indicator
adjacent to the Bluetooth button will ash and
T7 will provide audible feedback when it enters
“pairing” mode.
Note: T7 will automatically exit from Bluetooth
pairing mode if no device is paired within 5
minutes.
• Open the Bluetooth settings on the source
device and ensure Bluetooth is switched on.
Once discovered T7 will appear as an available
Bluetooth device. Select T7 and close the
Bluetooth settings. The T7 Bluetooth indicator
will ash as pairing is underway and illuminate
fully when pairing is established. T7 will also
provide audible feedback when pairing is
established.
Note: If your Bluetooth audio source device does
not support “simple” pairing and requests a four
digit code, enter ‘0000’.
• Once a connection has been established ensure
that T7 is selected as the speaker output. Audio
will now be heard through T7.
T7 will remember up to eight paired Bluetooth
devices. The rst paired device will be designated
as the “primary” device, additional devices will be
designated as “secondary” devices.
The master device will be connected when within
range, and the T7 Bluetooth button is pressed.
Secondary devices will not connect automatically
connect when in range but must be connected via
2 seconds
Devices
Bowers & Wilkins T7