Data Sheet

Alle Angaben gelten vorbehaltlich Druckfehlern. All information is subject to misprints.
Für Bestellungen oder bei Rückfragen kontaktieren Sie uns bitte unter | For order or inquiries please contact us at:
B&W International GmbH | Heike Brückmann | Fon 0 54 51 / 89 46-160 | Fax 0 54 51 / 89 46-444
heike.brueckmann@ b-w-international.com | www. bag2zero.com | www.b-w-international.com
Skin
Short single exposure is unlikely to cause skin irritation. Prolonged or repeated skin exposure may cause mild or
moderate skin irritation.
Inhalation
Vapours do not pose an acute health risk.
2. Chronic Health Effects
The components are not listed by IARC, NTP or PHSA as carcinogens for hazard communication purposes.
3. First Aid Swallowing
If swallowed give plenty of water. Treat symptomatically and consult a physician.
Eye
Irrigate with water immediately and continuously for at least 15 minutes. Consult a physician.
Skin
Wash affected area with water either locally or under shower. If irritation persists consult a physician.
Inhalation
In the event of any discomfort associated with vapour inhalation remove patient to a well ventilated fresh air area.
Rinse mouth and gargle with water. Consult a physician if irritation persists.
PRECAUTIONS FOR USAGE
1. Exposure standards
Exposure limits have not been established on TLV basis for continuously working with the product.
2. Engineering Controls.
Ensure adequate ventilation and standard dust control provisions
3. Personal Protection
No special PPG equipment is required for the handling of PC-16. However, good manufacturing practice will include
safety glasses and gloves.
4. Flammability
The product is not combustible and no special precautions are required in this respect.
SAFE HANDLING INFORMATION
1. Storage and Transportation
Transport and store the product under dry and cool conditions - ideally below 30 °C. Container should be sealed to
air tightness. The containers should be suitably flexible to retain containment integrity with a variation in volume of
the product of ~10% between its solid and liquid phases above and below -16 °C.
2. Spills and Disposal
Recovery of spilt solids or liquid should be placed in suitable, labeled containers for re-use. Wash down affected
area with excess water.
Where it is not possible to reuse the recovered product then disposal should observe all local, state and federal
regulations governing the disposal of ammonium and sodium chlorides.