Manual

B&W Custom Truck Beds, Inc.

1316R - 05 01 2014

STEP 10

Retract the latch pin by pulling the handle out until it stops and then rotating it. Place the 2-5/16” ball in the hitch

receiver. Engage the latch pin by rotating the handle. Be certain the latch pin passes through the holes in the Turn-

overball™ and fully engages through the hitch receiver. Grease the square base of the Turnoverball™.

STEP 9

Install the safety chain U-bolts. The center section may have multiple safety chain holes. Only 4 holes (2 on

each side of the ball) will need to be drilled. Each U-bolt will need to rest in the low part of a bed rib. To deter-

mine which holes will need to be drilled, carefully examine the safety chain holes in the center section to deter-

mine which holes are under a low rib, See gure 9.1. Use a 1/2" Drill bit and drill through the bed in the 4 low rib

locations, See Figure 9.2. Drop a U-bolt through each pair of holes from the top side of the truck bed oor. Place

a conical spring and lock nut on each of the four legs. Tighten the lock nuts until ush with the bottom of the U-

Bolts, See Figure 9.3.

FIGURE 9.1: Cut away view of bed and center section.

FIGURE 9.2: Cut away view from under the bed. FIGURE 9.3: Cut away view from under the bed.

LATCH

TAB

IN−LINE

DRIVER SIDE

STEP 8 – INSTALL LATCH PIN RELEASE HANDLE

WARNING: LATCH PIN WILL NOT FUNCTION PROPERLY IF HANDLE IS NOT INSTALLED CORRECTLY.

Install the latch pin release handle by inserting it through the

slot in the end of the center section on the driver’s side of the

truck. Align the handle eyelet with the square hole in the latch

pin so the handle is in line with the latch pin as shown. Secure

the handle to the pin with the 5/16 X 3/4” carriage bolt and 5/16”

locking ange nut as shown. Note: The included 5/16” cap screw

can replace the carriage bolt if wrench access on the “cab side”

of the handle is limited. Tighten the nut until it is secure. Do

not over-tighten and deform the handle eyelet.