User Manual

Turnoverball
TM
Gooseneck Hitch Installation Instructions
BEFORE INSTALLING
OVERHEAD LIFTING DEVICE
An overhead-lifting device, such as chain falls, engine hoist, or cable come-a-long, can
be used to lift the center section of the hitch in place. Lower a loop of rope or chain
through the 4” hole in the truck bed oor and attach it to the latch pin in the round hitch
receiver tube in the center section. Use the lifting device to raise the center section
until the round hitch receiver tube that protrudes from the center section ts in the 4”
hole in the truck bed oor. Maintaining upward pressure may facilitate fastening the
crossmember to the center section, especially if the truck bed oor has been distorted
downward from heavy use. If you use an overhead-lifting device, it should be discon-
nected before squaring the center section across the frame, installing the sideplates
and torquing fasteners.
Call or E-mail for installation support
Chevrolet & GMC (1973 - 1987)
1/2 - 3/4 - 1 Ton Trucks
Model 1400R
B&W Trailer Hitches
1216 Hawaii Road / PO Box 186
Humboldt, KS 66748
620.473.3664
800.248.6564
Fax: [phone]
[e-mail]
www.turnoverball.com
NOTE: We recommend reading instructions before beginning the installation.
WARNING: The tow vehicle’s towing capacities should under NO circumstances be exceeded.
Mounting Kit Box (GNRK1400)
ITEM DESCRIPTION QTY
1 Center Assembly 1
2 2-5/16” Ball 1
Mounting Kit Bolt Bag
1/2" X 1-1/2" Carriage Bolt 4
1/2” Finish Nut 4
1/2” Lock Washer 4
1/2" Flat Washer 4
Safety Chain Kit Bolt Bag
3 1/2" U-Bolt 2
4 Conical Springs 4
5 1/2" Lock Nut 4
5/16" X 3/4" Carriage Bolt 1
5/16" X 3/4" Cap Screw 1
5/16" Flange Nut 1
NOTICE: This product was designed to t vehicles in their original, “as manufactured” condition. Compatibility with vehicles having
replacement parts, or other modications is not guaranteed. Inspect vehicle for modications before installation of this product.