Datasheet
26
Hard plastic cap with two spring-loaded plastic claws opposite each
other that engage the front thread of the lens (or lter). Simple re-
moval by pressing the two buttons together means fast and uncom-
plicated one-hand operation.
Available in the following thread sizes: 46 E, 48 E, 4 E, 2 E, E,
8 E, 62 E, 2 E and E.
Protective cap made of exible plastic material that slips over the
outer front rim of the lens or lter. It remains in place by means of
friction of the slip-proof plastic material. Very simple to handle. This
lens cap can also be used on an attached slim lter that has no front
thread.
Available for lens or lter front rim diameters: 2, 0, 2, , 42, 1,
4, , 60 and 0 mm.
This cap corresponds in all its features to the 00 except for thick-
ness. The Slim 0 is made of exible plastic and tailored speci cally
to the at Slim lter mounts. This at lens cap is advantageous when
the front rim of the lens is slightly larger than the Slim lter, so that a
normal lens cap could not be slipped on completely.
Available for the following Slim lter mounts: 4 E, 2 E, E, 8 E,
60 E, 62 E, 6 E, 2 E, E and 82 E, or for the corresponding outer
lter diameters 2, , 8, 61, 62, 6, 0, , 80 and 8 mm.
Hard protective cover for the camera-side rear bayonet or thread
of the lens.
Available for lenses of Canon FD (0), Minolta MD (1), Nikon (2),
Olympus OM (), Pentax K (4) and M-42 thread ().
Hard protective covers for the bayonet or thread lens mounts on
camera bodies.
Available for SLR cameras with the following lens mounts:
Canon FD (20), Minolta MD (21), Nikon (22), Olympus OM (2),
Pentax K (24) and for M-42 thread mounts (2). These camera body
covers can also be used as front protective covers on tele-convert-
ers, provided their optical systems are suf ciently recessed in their
mounts.