Owner`s manual

M1u

GND (GROUND CONNECTION)

For connection to the chassis’ ground.

For optimum performance 0 gauge cable is

required, all of them using common ground

connected with cable of equal length.

REM (REMOTE)

Connect to switched +12V from the head unit.

Installation of the amplifier shall be done in the following steps.

1. Ensure the ground is appropriate, then connect it to the amplifier. 2. Connect the +12V wire,

keep in mind this wire has to be fused at the battery as well. Ensure all input terminals are used

& that fusing is needed at the amplifier also. 3. Connect the switched remote. 4. Reattach the

negative wire (ground) to the battery. 5. Operation over 16 V will caust the amplifier to go into

protect & will eventually void the warranty!

CAUTION

2. Panel layout

+12V (POWER CONNECTION)

For connection to the positive terminal

of the battery (+12V).

For optimum performance 0 gauge cable

is required.